PRECISION IN MATERIAL. CLARITY IN SUPPLY.

STANDARDS AND CERTIFICATES

How to check stainless steel quality

A magnet does not show the grade. The grade name, the analysis on the EN 10204 3.1 certificate, the lot number on the material and, where needed, XRF or OES analysis are read together.

On this page

Stainless steel is not a single material

Stainless steel is a family of many grades with different compositions and internal structures. A grade name such as 304 or 1.4301 stands for the composition limits written in a standard. Under EN 10088-3:2023, 1.4301 has 17.5–19.5 % chromium, 8.0–10.5 % nickel and at most 2 % manganese.

So the answer to “is this good stainless?” is whether the delivered material really meets the limits of the ordered grade. Surface brightness or appearance does not show this.

A magnet test does not show the grade

Annealed austenitic stainless steels such as 304 and 316 are generally not attracted to a magnet. When the same steels are cold worked, that is bent or drawn without heating, part of the structure turns into martensite and they can be attracted. This does not mean the material is fake or of low quality.

Ferritic and martensitic stainless steels are strongly attracted to a magnet even when annealed. Duplex grades are attracted too because they contain about half ferrite. Conversely, not every material a magnet ignores is 304: the low-nickel grades described below are not attracted either.

Low-nickel 200-series stainless steels

In 200-series (CrMn) stainless steels part of the nickel is replaced by manganese and nitrogen, sometimes copper. They may be chosen for their lower price. In the lowest-nickel types, chromium also falls to about 15–16 %, against about 18 % in 304, and corrosion resistance drops noticeably.

They are not attracted to a magnet and look stainless at first, so they are often taken for 304 or 316. XRF analysis or drop test kits for manganese and molybdenum are used to tell them apart. Users are advised to have quality control that prevents the wrong grade from being installed.

What to check on an EN 10204 3.1 certificate

A 3.1 inspection certificate contains a statement of order conformity and inspection results representing the supplied product. It is validated by the manufacturer’s authorised inspection representative, independent of manufacturing.

Check that the grade and standard on the certificate match the order, that the chemical analysis stays within that standard’s limits, and who the issuing producer is. A heat or lot number that matches the marking on the material shows the certificate belongs to the material in hand.

Checking by analysis: XRF and OES

A handheld XRF analyser can measure the elements needed to identify a grade such as 316 and can separate chromium-manganese from chromium-nickel stainless. It cannot measure carbon, however, so XRF does not show the difference between 316 and the low-carbon 316L.

Where carbon matters, OES (optical emission spectrometry) is used. OES measures carbon and so separates low- and high-carbon stainless grades.

A short checklist when buying

These checks judge the grade by documents and measurement rather than by appearance or a magnet:

  • The grade and the standard named together on the quotation and invoice (e.g. 1.4404 / EN 10088-3).

  • An EN 10204 3.1 inspection certificate supplied with the material.

  • The heat or lot number on the certificate matching the marking on the material.

  • Chemical analysis values within the standard’s limits.

  • Verification by XRF where needed, and by OES where carbon matters.