TURNING
Taper calculator: taper angle, ratio and tailstock offset
Enter the large and small diameter and the taper length to calculate the taper ratio, the angle to set on the lathe and the tailstock offset. If you know the angle, you can find the small diameter instead.
Taper dimensions
The half angle is the angle set on the compound rest. For tailstock offset enter the total length of the part between centres.
tan(α/2) = (D − d) / 2L
Taper
- Half angle (α/2)
- 1.432° · 1° 25′ 56″
- Included angle (α)
- 2.864° · 2° 51′ 51″
- Tailstock offset (S)
- 5 mm
Taper formulas
The taper is the difference in diameter divided by the taper length: C = (D − d) / L, usually written 1 : x with x = L / (D − d). The angle set on the lathe is the half angle: tan(α/2) = (D − d) / (2 × L); the included angle is twice that. For D = 30, d = 25, L = 100 mm the taper is 1 : 20, the half angle 1.432° and the included angle 2.864°.
Taper turning methods
Short tapers are turned by setting the compound rest to the half angle. For long, shallow tapers the tailstock is offset: S = (D − d) / 2 × Lt / L, where Lt is the total length of the workpiece between centres. In the example above a 200 mm workpiece needs S = 5 mm. On a CNC lathe the taper is programmed directly from the start and end diameters.
Frequently asked questions
How is taper calculated?
Subtract the small diameter from the large one and divide by the taper length: C = (D − d) / L. For the 1 : x form, x = L / (D − d).
How is the taper angle calculated?
The half angle is α/2 = arctan((D − d) / (2L)); the included angle is twice that. The compound rest is set to the half angle.
How is the tailstock offset found?
S = (D − d) / 2 × Lt / L, with Lt the total workpiece length and L the taper length. If the whole part is tapered, S = (D − d) / 2.