WELDING
Welding heat input calculator
Choose the welding process and enter voltage, current and travel speed. Arc energy and heat input to EN 1011-1 are calculated in kJ/mm.
Welding parameters
The thermal efficiency k is the EN 1011-1 value for the process. Travel speed is the weld length divided by the arc time.
Q = k × U × I × 60 / (v × 1000)
Heat input
- Arc energy (E)
- 1.4 kJ/mm
- Heat input (kJ/cm)
- 11.2 kJ/cm
Thermal efficiency by process (EN 1011-1)
Thermal efficiency factor kISO 4063 no. · k
| Process | ISO 4063 no. | k |
|---|---|---|
| Manual metal arc (MMA / SMAW) | 111 | 0.8 |
| MAG (active gas) | 135 | 0.8 |
| MIG (inert gas) | 131 | 0.8 |
| Flux-cored wire (FCAW) | 136 | 0.8 |
| TIG (GTAW) | 141 | 0.6 |
| Submerged arc (SAW) | 121 | 1.0 |
Heat input formula
Per EN 1011-1, arc energy is E = U × I × 60 / (v × 1000) kJ/mm, with U the arc voltage (V), I the welding current (A) and v the travel speed (mm/min). Heat input is the arc energy times the process thermal efficiency: Q = k × E. For MAG at 28 V, 250 A and 300 mm/min, E = 1.4 kJ/mm and with k = 0.8, Q = 1.12 kJ/mm.
Thermal efficiency factor (k)
The factor is the share of arc energy that reaches the workpiece. EN 1011-1 gives 1.0 for submerged arc; 0.8 for MMA, MIG, MAG and flux-cored; and 0.6 for TIG. Check whether the welding procedure (WPS) asks for arc energy or heat input; some specifications use the value without k.
Why heat input matters
Heat input controls the cooling rate of the weld zone. Low heat input means fast cooling and a hard heat-affected zone, with a higher cracking risk; high heat input can cause grain growth and loss of toughness. For stainless and duplex steels heat input is usually kept within limits to preserve phase balance and corrosion resistance. The right range depends on material, thickness and procedure.
Frequently asked questions
How is welding heat input calculated?
Q = k × U × I × 60 / (v × 1000) kJ/mm: multiply voltage (V) by current (A) and by 60, divide by travel speed (mm/min) and by 1000, then multiply by the process factor k.
What is the thermal efficiency factor for TIG?
Per EN 1011-1, k = 0.6 for TIG (141); 0.8 for MAG, MIG, MMA and flux-cored; 1.0 for submerged arc.
Are arc energy and heat input the same?
No. Arc energy is U × I × 60 / (v × 1000); heat input is that value multiplied by the thermal efficiency factor k. The terms used to be used interchangeably.